1. HT Series chamber liners are first
secured in place with a high temperature adhesive.
2. A 1/2" x 3/4" stainless steel tab
stop is them welded in place, positioned at six o'clock on the open end or
outlet side of the chamber as a mechanical stop. (The tab can be bent to
allow for future replacement as necessary.)
Note: Early models did nothave a stainless steel tab. If the unit does not have a stainless
steel tab, fasten in place by placing a small amount of Furnace Cement
(about 1/2" high x 1" diameter) at the open or outlet side of the chamber in
the six o'clock position. This is the same location as we presently position
the stainless steel mechanical stop.